Turntable Servicing

IMPORTANT: Decks must be stored in the correct position to avoid loss of hub/bearing lubricant.

When first setting up turntable

The following is only really necessary for turntables in cold countries with low humidity, or for turntables that have been in stock for a long period.

1. Check arm nut tightness. This should be between 15Nm and 25Nm ( see explanation of torque ) and requires either an adjustable spanner or Rega tool.

2. Check hub/bearing nut tightness. This should be approx. 5Nm ( again refer to exlpanation of torque ) and requires either an adjustable spanner or Rega tool.

After 5 years

1. Check tightness of both arm nut and hub bearing nut as above.

2. Check motor pulley is firmly attached. If loose, replace, (See refitting the turntable motor pulley)

3. Remove any hair, fluff or dirt from around the motor spindle and place one drop of motor oil in both motor bearings, situated at the top and bottom of motor around spindle (see Cleaning and Re-oiling motor)

4. Replace drive belt, if worn. (This is usually indicated by the turntable running fast).

5. Check arm bearings. If faulty, do not attempt to adjust. Return arm to Rega

6. If necessary, clean and re-grease lift/lower. (See Cleaning and replacement of lift/lower)

After 10 Years

Carry out all instructions listed under "After 5 Years" with the addition of the following points;

1. Remove hub/bearing and clean and re-oil. (Cleaning Hub/Bearing)

2. Remove motor cover plate and undo motor mounting screws.

3. Replace motor suspension 'O' ring as described here

4. Refit motor following the instructions Fitting Motor

5. Replace drive belt.