| Arm
Height Adjustment Spacers |
|
Arm
Height Adjustment spacers for RB250, RB300, RB700 and RB1000. When
Rega arms are fitted to turntables from other manufacturers it may be necessary
to add our "Rega arm spacers" to achieve the correct arm height. Circular
spacers are available for the RB250 and RB300 in thickness' of 2mm, 4mm and 10mm.
An arm "Sleeve nut" is also available for circumstances where the arm
base does not protrude below the arm mounting board. The
RB700 and RB1000 use the custom made 3 point 2mm thick spacer as pictured above
right. Note:
On all Rega turntables spacers should not be necessary. Arm
Height or V.T.A adjustment can be a controversial subject. Rega believes that
the integrity of the arm fixing onto the arm mounting board is much more important
than the questionable facility of arm adjustment: The arm should be reasonably
parallel to the record surface or slightly lower at the mounting. The only time
a spacer is necessary to raise the arm height is if the rear of a cartridge is
hitting the record whilst playing. |
|