All in one 2mm, 4mm, 6mm and 8mm height adjustment spacer for Rega 3 point tonearms.

When Rega arms are fitted to turntables from other manufacturers it may be necessary to add our "Adjustable arm height spacer" to achieve the correct arm height.

Adjustment is rarely required on Rega turntables, if adjustment is necesscary it is recommended to remove the lid when using the 4mm and above setting as the balance weight may contact the lid.

A smaller diameter tungsten weight is available from your Rega dealer for use with the RB301 to solve this issue.

Note: On all Rega turntables spacers should not be necessary, unless using another manufacturers cartridge.

Arm Height or V.T.A adjustment can be a controversial subject. Rega believes that the integrity of the arm fixing onto the arm mounting board is much more important than the questionable facility of arm adjustment: The arm should be reasonably parallel to the record surface or slightly lower at the mounting. The only time a spacer is necessary to raise the arm height is if the rear of a cartridge is hitting the record whilst playing.