Rega 2 mm Three Point Arm Height Spacer - Stainless Accessory

2mm Three Point Arm Height Adjustment Spacer - Stainless

Some other manufacturers cartridges may have a deeper body than Rega cartridges, these will sometimes require the use of the three-point spacer to allow clearance of the rear of the cartridge from the vinyl.

When Rega arms are fitted to turntables from other manufacturers it may be necessary to add our Rega arm spacers to achieve the correct arm height.

Note: On Rega turntables, spacers should not be necessary unless you are you using an exceptionally deep-bodied cartridge from another manufacturer.

Arm height or V.T.A adjustment can be a controversial subject. Rega believes that the integrity of the arm fixing onto the arm mounting board is much more important than the questionable facility of arm adjustment. The arm should be reasonably parallel to the record surface or slightly lower at the mounting. The only time a spacer is necessary to raise the arm height is if the rear of a cartridge is hitting the record whilst playing.

Rega 2 mm Three Point Arm Height Spacer - Stainless Accessory

Experience Rega

Contact your nearest Rega dealer or global distributor

Lifetime Limited Warranty

All Rega products carry a Lifetime Limited Warranty.

Every product we make is designed and assembled in the UK to the highest possible standard. This warranty covers confirmed manufacturing defects. This warranty does not cover wear and tear, or parts that are considered consumable. Any unauthorised modifications or failure to follow the Rega recommended guidelines in the product manual may invalidate the warranty. Due to local laws, warranties may vary by country in which units are sold. Please contact your Rega retailer or distributor for warranty details. Your statutory rights are not affected.